As a cleaning company owner, exactly how many times do you find filthy mop pails, grimy gear, vacuum cleaners that have not been emptied, and spray bottles that spray correctly and walk into a janitor closet? Have you or your managers taken the time to train your employees on how to properly take care of your equipment? Use this checklist to help keep your supplies and equipment in top working condition.
Plastic Spray Bottles
Wipe bottles as necessary to avoid deposit and accumulation
Replace label when wanted
Occasionally take apart cause and clean to avoid clogging
Brute & Caddy
Wipe down inside and out as needed
Do not leave lying around - they really are a security and disorder danger. Keep in a bag for filthy rags
Disinfect and wipe front edge as needed
Excess, shakes out. If brush is dirty, wash it out and rinse with clear water. Let dry with bristles straight.
Storage - hang brush - don't set the brush weight.
Don't use when wet, do not stand on its straws. Do not use broom. Therefore it is going to wear equally rotate frequently.
After every days use, wipe knife to eliminate moisture and debris.
Store in clean, dry place.
Border needed to make sure it stays sharp
Rinse with water immediately.
Don't use dust mops on floors that are greasy.
Remove loose soil frequently, utilizing a vacuum cleaner if possible; otherwise shake into substantial waste receptacle.
Never keep a mop on the floor. Hang air can circulate.
Soak for a number of minutes to get rid of sizing, before employing a new mop and toughen the fibers.
Rinse after use.
Do not twist the mop in the wringer. It might be ruined as the fibers will break if it is squeezed too challenging or twisted.
Use your fingers to straighten the fibrils.
Cut loose or irregular fibrils off.
Never store on the floor or in the mop bucket.
Flooring Finish Mops
After using, wash out all floor finish or wax with clean water.
Wring out as much water as you possibly can, shake to fluff fibrils.
Never use soap or detergent on a mop intended for floor finish.
Place mop after use in a clean plastic bag.
Pails & Wringers
Do not use force on a wringer lever - use only enough hand pressure on the lever to wring out the mop.
Remove that becomes tangled in the wringer.
Scrub and wash all surfaces of the pail with disinfectant. Rinse with warm water and wipe dry. Keep wringer tight and oiled.
Keep wringer in "release" location if it is not being used.
Rinse blade in clean water after use.
Dry, don't store with blade down or crouched.
Upright Vacuum Cleaners
Empty tote frequently.
Wipe outside of vacuum after emptying.
Assess for cuts in belt and change when needed.
Empty magnet bar after every use.
Wipe down whole surface after each day's use. Additionally wipe cord.
Assess pad for replacing.
Blow out motor about every 2 weeks.
Check bolts and screws to ensure they are tight.
Wipe down whole surface after the use of each day. Also wipe twine.
Rinse tank after each use.
Check drive unit for cracks on wear.
Synthetic Floor Pads
Floor pads may be used on both sides. The pad must be set aside for soaking or cleaning once both sides are used.
Flooring pads can be cleaned by rubbing against one against the top of another one. Or you also can make use of a hand scratcher. Pads that tend not to react to this procedure ought to be soaked overnight in a concentration of synthetic detergent or stripping solution. Pads are not ready for reuse until they are entirely dry.
Hint: When pads become excessively worn, they window cleaning stuff are able to be cut into small sections that may be used as hand or foot scratch pads.
Rinse out inside, wipe outside and in after each use.
Rinse and wipe hoses and attachments.
Rinse out in of tank, filters, hoses and attachments.